Content

General

• General description
• Specifications
• Construction and operation

Service standards

• Engine
• Adjustment standards
• Service standards

Special tools

Inspection and adjustment of engine

• Tightening torque table
• Sealant, oil and grease

Removal and installation of auxiliaries

• Measurement of compression pressure
• Oil pressure
• Inspection and adjustment of valve clearance
• Bleeding of fuel system
• Inspection and adjustment of fuel injection start timing
• Inspection and adjustment of no-load minimum and maximum speeds
• Inspection and adjustment of v-belt tension troubleshootin

Engine proper

• Preparations
• Removal and installation

Inlet and exhaust

• Disassembly
• Inspcetion and correction
• Reassembly

Lubrication

• Oil pump
• Oil filter
• Oil cooler
• Relief valve
• Regulator valve
• Check valve

Cooling

• Water pump
• Thermostat
• Radiator
• Cleaning
• Cooling system
• Gas leakage test

Fuel

• Injection pump general
• Injection nozzle
• Fuel filter
• Water separator

Electrical

• Starter
• Starter relay
• Alternator
• Preheater

Other equipment

• Air compressor
• Injection pump drive
• Automatic stop system
• Over heat warning unit
• Oil pressure switch