Content
Engine list
Service work
-
Information about flexible or fixed service
-
Service tables
General information
-
General warnings for working on high-voltage system
-
Raising vehicle with lifting platform or trolley jack
-
Entries in service schedule
-
Severe operating conditions
-
Vehicle data sticker
-
Connecting vehicle diagnostic tester
-
Vehicle identification number
-
Countries with hot climate
-
Country overview for diesel not compliant with EN 590
-
Country overview for petrol not compliant with EN 228
-
Engine code and engine number
-
Countries with high levels of dust
-
Type plate
-
Shortened intervals for spark plug replacement
Descriptions of work
-
Swivel joints and suspension link mountings: inspecting
-
All-wheel drive coupling: changing oil
-
Automatic headlight control and static cornering light: checking function
-
Automatic gearbox 09S: changing ATF
-
Battery (12V): checking battery terminal clamps for secure seating
-
12-volt battery: renewing
-
Battery (12V): checking with battery tester (always refer to workshop manual)
-
Status of battery (12V): reading - sending diagnosis protocol via online connection
-
Front passenger front airbag: checking key switch and “ON/OFF function”
-
Tyres: checking condition, wear pattern, tyre pressure and tread depth
-
Brake and clutch system: Change brake fluid
-
Brake system and shock absorbers: inspecting for leaks and damage
-
Brake fluid level: Check
-
Brakes, front and rear: checking thickness of brake pads and condition of brake discs
-
Diesel fuel filter: draining
-
Diesel fuel filter: renewing
-
Diesel particulate filter: checking
-
Dual clutch gearbox 0DD: changing gear oil
-
Dual clutch gearbox 0GC: changing gear oil
-
Electric windows: checking positioning (open and close functions)
-
Fault memory of all systems: reading with vehicle diagnostic tester, correcting possible faults according to repair guidelines
-
Natural gas system: resetting interval display if a check in line with ECE ruling 110 has been carried out
-
Natural gas system: visually inspecting natural gas tank for corrosion and leakage
-
Natural gas system: checking wax layer between natural gas fuel tank and fuel tank shutoff valve
-
Natural gas tank: renewing
-
Natural gas filler connection and sealing cap: checking condition, if necessary cleaning and checking seal
-
Boots: inspecting
-
High-voltage battery: checking charge level
-
Maintenance of high-voltage battery
-
High-voltage battery: charging
-
Hybrid components: inspect for damage to high-voltage components and wires
-
Interior and exterior body: inspecting for corrosion with doors and flaps open
-
Poly V-belt: renewing
-
Poly V-belt: checking condition
-
Poly V-belt and tensioning roller for belt-driven starter-alternator: renew
-
Poly V-belt and tensioning roller for belt-driven starter-alternator: check
-
Cooling system: checking frost protection and coolant level
-
Cooling system for high-voltage system: checking coolant additive and coolant level
-
Air filter: cleaning housing and renewing filter element
-
Multi-purpose additive for diesel fuel: adding
-
Multi-purpose additive for petrol fuel: adding
-
Engine and components in engine compartment: inspecting for leaks and damage (from above and below)
-
Engine cover panel “top”: removing and installing
-
Engine data plate with Certification Test Group code: checking if fitted and for condition, also checking CTG code against the code in the engine control unit
-
Engine compartment cover (noise insulation) “bottom”: removing and installing
-
Engine oil level: checking
-
Engine oil: Draining, renewing oil filter and filling engine oil
-
Engine oil: capacities and specifications
-
Panoramic sliding sunroof
-
Panorama sliding roof with rear panorama roof
-
Road test: performing (driving behaviour, noises, air conditioner etc.)
-
Wheel securing bolts: tightening to specified torque
-
Reducing agent (AdBlue®/DEF): replenishing
-
Reducing agent (AdBlue®/DEF): changing
-
Tyre Pressure Loss Indicator: calibrating
-
Tyre repair set: Checking
-
Window wash/wipe system: functional check
-
Headlight adjustment: checking LED headlights
-
Headlight adjustment: checking matrix LED headlights
-
Headlight adjustment: checking fog lights
-
Service interval display: resetting
-
Service interval display: recoding
-
Track rods: checking clearance, attachment and boots
-
Dust and pollen filter: cleaning housing and renewing filter element
-
Selective wheel torque control: change oil in left and right clutch chambers
-
Transportation mode: switching off
-
Transportation devices: removing blocking pieces
-
Clock and date: setting
-
Underbody: inspecting for damage to underbody sealant, underbody panels, routing of lines, plugs
-
Front differential lock: changing oil
-
Warning stickers, Golf GTE: checking
-
Toothed belt (petrol engines): renewing
-
Camshaft drive toothed belt (diesel engines): renewing
Spark plugs: Renew
Exhaust emissions test
-
Exhaust emissions test for petrol engines
-
Exhaust emissions test for diesel engines
Periodic Technical Inspection (PTI)
Glossary
Change history